AC Simulator - Regatron

Parameters

  • phases: Phases (default: 3)
  • wiring: Wiring (default: LN)
  • phase_angle: Phase Angle (default: 120)
  • v: Nominal LN Voltage (default: 277)
  • v_max: Max Voltage (L-N RMS per Phase) (default: 300)
  • i_max: Max Current (default: 100)
  • freq: Frequency (default: 60.0)
  • comm: Communications Interface (default: TCP)
  • new_block: Build and Run New Block (default: No)
  • serial_port: Serial Port (default: COM1)
  • baudrate: Baud Rate (default: 115200)
  • bytesize: Byte Size (default: 8)
  • parity: Parity (default: PARITY_NONE)
  • stopbits: Stop Bits (default: 1)
  • xonxoff: XON/XOFF (default: False)
  • rtscts: RTS/CTS (default: False)
  • dsrdtr: DSR/DTR (default: False)
  • ipaddr: IP Address (default: 192.168.0.90)
  • ipport: IP Port (default: 2000)
  • dll_path: Full Path to Regatron DLL (leave blank for default) (default: ..\target_def_support\RegatronAPI\x86\Ch.Regatron.ACS.MID.AcsApi.V2.8.1.2.dll)
  • offline_mode: Offline Debug Mode (default: No)
  • init_delay: Initialization Delay (default: 30)

Operations

Get Operations

  • Device Info
  • AC Output State
  • Voltage
  • Frequency
  • Voltage Harmonics
  • Current Harmonics
  • Voltage THD
  • Current THD
  • Measurements
  • Query
    • qstr: Query String (default: )

Set Operations

  • AC Output State
    • state: AC Output State (default: )
  • Voltage
    • v: Voltage - All phases (V) (default: )
    • v1: Voltage - Phase A (V) (default: )
    • v2: Voltage - Phase B (V) (default: )
    • v3: Voltage - Phase C (V) (default: )
  • Frequency
    • hz: Frequency (Hz) (default: )
    • hz_slew_rate: Frequency Slew Rate (Hz/sec) (default: )
  • Phase Angles
    • ph1: Phase 1 Angle (deg) (default: 0.0)
    • ph2: Phase 2 Angle (deg) (default: -120.0)
    • ph3: Phase 3 Angle (deg) (default: -240.0)
  • AC Profile
    • prof_name: Profile Name (default: )
  • Command
    • cstr: Command String (default: )
  • Start AC Profile